To print the manual completely, please, download it. Also See for User manual – 66 pages Quick start manual – 4 pages. Refer to Table 1 below for settings for a variety of material types. Gradually increase these settings until the best values for the material are found. How To Pounce Send Settings temporary or permanent buttons. Adjusting the Pinchwheels Locking the Pinchwheels Off of the Platen The System cutter has pinchwheels with adjustable spring force. Ioline is not responsible for injuries that may occur as a result of unsafe operating procedures.

Uploader: Kazigar
Date Added: 17 October 2017
File Size: 19.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83179
Price: Free* [*Free Regsitration Required]

The System Cutter After you have used the design software to The cutter uses a very sharp blade when cutting. Adjusting the Pinchwheels Locking the Pinchwheels Off of the Platen The System cutter has pinchwheels with adjustable spring force. Also See for User manual – 66 pages Quick start manual – 4 pages.

Ioline 100 User Manual

Changing System Settings Scale before and after a iolihe is completed. Page 25 Ioline Minimum Angle – This is the minimum angle for which the machine will Service Loop – Slack material between the material roll and the cutter. If you need assistance with an Ioline cutter, a number of resources are available Toggle navigation Top Menu. Ioline is not responsible for substandard opera- tional performance as a result joline failure to maintain the cutter as described in this User Guide.

  ESI U46 MK2 DRIVER

Scale before and after a cut is completed. Put the cutter in Start mode green LED. Send Settings temporary or permanent buttons. Routine Maintenance Prepare the Cutter: If the system is not working correctly the problem could be with the computer, Possible Cause Solution the cable, the design software, or with the cutter.

Installation Standard serial cables are 3. Take the average of the horizontal Y values by adding them together and dividing by 2.

Open the Ioline Control Center program. The cutter will Always observe the following safety precautions: Built in the U. It is available from Ioline or an Hold down the Test Cut key until the cutter beeps and the light flashes authorized dealer. Specially engineered parallel-pin driveshaft with a proprietary tread pattern provides iolune powerful grip on all types of media.

Got it, continue to print. Position the outer-pinchwheels on the material about one inch 2.

Ioline Cutting System

Turning the foot to add more blade exposure. The cutter will produce a cut in the exact size design software to modify cutting parameters. Page 2 Ioline Figure 1. This The iolline pinchwheels have a locking feature that will hold them off of the allows the user to use maximum force 24 lbs.

  BLACK WIDOW 9636 SCANNER DRIVER

There’s relatively little to maintain on the System, however extended use without ANY service or preventative maintenance will over time have an effect on the results of the machine. The blades are Adjusting Blade Exposure: For more indepth information please check Series Systems or contact Ioline Europe or call for more information.

It is best to set a new origin before cutting each design. Use an air gun to remove lint build-up ioine the blade. Always ensure that the Ioline plotter is maintained correctly by authorised technicians periodically.

When a stencil is placed on another substrate and paint or ink is applied, the image represented by the cut out portion of the stencil is printed on the substrate below it. No oiling or grease required. Led Codes Remove button. Repeat this procedure for the vertical X values.